PRG0802-LED Runner

Major Features:

• Low power CMOS design
• Wide power supply range from 3.0 to 5.5 volt.
• Low power mode to saves batteries
• Single push-button to activate LEDs running
• Direct drive for high current outputs
• No expensive external timing components required

The Au Group Electronics PRG0802 is an 8-pin 8-bit flash microcontroller with integrated program. The PRG0802 is a fun circuit for driving up to five LEDs. One push button input will initiate about 15 to 20 seconds of LED “running” activity. Its low current consumption feature makes it also a good candidate for battery-powered toys.

All of the control logic required for circuit operation is contained within the PRG0802 8-pin integrated circuit. Normally only batteries, 5 LEDs, 1 push button switch, and 2 resistors are needed for a completed LED runner circuit. The PRG0802 drives each LED output in a sequential fashion at approximately 2~3 Hz frequency. With one LED output at a time the current will be maintain at the lowest level.

PRG0802 Application Note

PRG0802P-LED Runner (PDIP) Part # PRG0802P        Price: $5.99(USD)
PRG0802SN-LED Runner (SOIC) Part # PRG0802SN        Price: $5.99(USD)